What Details Should You Pay Attention to When Installing Solar Road Studs?

Whether the solar road studs are installed correctly or not is related to their use effect. The installation process of solar LED road studs is indeed not complicated, but there are still many details that need special attention during the installation process. Only by doing every detail well can the solar powered road studs be installed correctly and achieve the maximum effect during use. So what details do you need to pay attention to when installing solar road studs?

Solar powered road reflectors need to rely on sunlight to charge, so the installation location needs to be able to fully receive sunlight and avoid obstruction. At the same time, solar road studs should also avoid being installed in places where water often accumulates. Although they are waterproof, long-term moisture or soaking in water will also affect the normal operation of the road studs.

When you install solar road studs, please make sure that the solar panels are facing upward to maximize the reception of sunlight, and make sure that their direction is perpendicular to the ground to avoid the deflection angle affecting the conversion efficiency of photovoltaics. When installing solar powered road studs, it is necessary to keep the same direction as the road to avoid misleading vehicles into the wrong lane.

Before you install the road studs, please make sure that the road surface is flat and clean, without oil and dust, and has no obvious potholes, to prevent a poor fixing effect. When fixing solar road studs, you can choose to use professional adhesives or stainless steel screws, nails, etc., to ensure that the road studs can be firmly fixed on the ground to prevent vibration or external force from causing the road studs to fall off and affect traffic safety.

An inspection should be carried out within two hours after the installation of solar road studs to ensure that all road studs are not installed upside down, crooked, or pressed. Wait for the road studs to cure for 4 hours before removing the installation isolation facilities to ensure that the glue is fully cured and the road studs are tightly connected to the ground. If the isolation facilities are removed before the curing time is insufficient, the solar powered road reflectors may be deformed or fall off when impacted and crushed by vehicles.

The premise of installing solar LED road studs is that they cannot affect or hinder the normal driving of vehicles and pedestrians, especially on some narrow roads or busy intersections. Be sure to avoid road studs protruding from the road surface to prevent tripping or damage to vehicle tires. When installing solar powered road studs, make sure they are neatly arranged, brightly colored, and bright enough to provide clear visual guidance for drivers.

When installing solar powered road reflectors, you should ensure that your installation complies with relevant traffic safety regulations, especially those related to road markings. The regulations on night lighting and road stud design must follow industry standards to ensure that they can be installed on the road for good use.

Although solar road studs are small in appearance, their installation is also very knowledgeable. As an electronic safety facility used on the road, you should pay attention to choosing the appropriate installation location and adjusting the angle and direction of the solar panels during installation to ensure that they can operate correctly and efficiently. Before installation, you should organize the road conditions, pay special attention to the installation process, and choose the correct fixing method. After the installation is completed, you should pay attention to the inspection and only resume traffic when the conditions are met. Only correct installation can ensure the effectiveness of solar road studs.